Emergency Stop; Tires & Wheels - Mec 1330SE Service And Parts Manual

T & W
I R E S
Maintaining the tires and wheels in good condition is essential to safe operation and
good performance. Tire and/or wheel failure could result in a machine tip-over.
Component damage may also result if problems are not discovered and repaired in a
timely fashion.
1. Check the tire surface and sidewalls for cuts, cracks, punctures and unusual wear.
2. Check each wheel for damage, bends and cracks.
3. Remove the wheel covers and check each center lock nut for proper torque.
Castle nut torque, dry
Castle nut torque, lubricated
E
M E R G E N C Y
A properly functioning Emergency Stop system is essential for safe machine operation.
An improperly operating red Emergency Stop button will fail to shut off power and stop
all machine functions, resulting in a hazardous situation.
As a safety feature, selecting and operating from the ground controls will override all
platform controls except the platform red Emergency Stop button.
1. Turn the key switch to ground control and turn the red Emergency Stop button clock-
wise to the on position at both the ground and platform controls.
2. Push in the red Emergency Stop button at the ground controls to the off position.
• Result: No machine functions should operate.
3. Turn the key switch to platform control and turn the red Emergency Stop button clock-
wise to the on position at both the ground and platform controls.
4. Push in the red Emergency Stop button at the platform controls to the off position.
• Result: No machine functions should operate.
NOTE: The red Emergency Stop button at the ground controls will stop all machine operation, even if the key switch
is switched to platform control.
July 2017
Page 1-6
H E E L S
19 ft-Ibs / 26 Nm
14 ft-Ibs / 20 Nm
S
T O P
"1330SE" Service and Parts Manual
F I
R E Q U E N T N S P E C T I O N
C
H E C K L I S T