Do you have a question about the 2033ES and is the answer not in the manual?
Questions and answers
rick novak
April 5, 2025
need 2033 rear wheels to roll
1 comments:
Mr. Anderson
April 6, 2025
To make the rear wheels of the Mec 2033ES roll:
1. Ensure wheels are chocked to prevent movement. 2. Open the tow valve by turning it. This manually releases the rear brakes. 3. The machine can then be winched or moved short distances at speeds not exceeding 5 mph (8.05 km/h).
This answer is automatically generated
Lisa
February 11, 2025
Lift only goes up half way
1 comments:
Mr. Anderson
February 12, 2025
The MEC 2033ES lift may only go up halfway due to several possible reasons:
1. Lift Capacity Exceeded – If the weight on the platform exceeds the rated capacity (800 lbs or 500 lbs, depending on the model), the lift may not fully extend.
2. Battery Charge Issue – If the battery is not sufficiently charged, the lift may not have enough power to reach full height. Check the battery charger LED indicators to confirm the charge level.
3. Hydraulic System Problem – A malfunction in the hydraulic manifold assembly, such as a faulty relief valve, spool valve, or coil, could limit the lift’s movement.
4. Preventive Maintenance Needed – If maintenance has not been performed at the recommended intervals, defects or malfunctions could prevent full extension.
5. Defective or Malfunctioning Component – Any defect in the lift system should be reported and repaired before further use, as operation with a defect can cause injury or system failure.
A qualified technician should inspect the lift to identify and fix the exact issue before continued use.
This answer is automatically generated
Timoyhy Scully
February 11, 2025
what is total weight w batteries
1 comments:
Mr. Anderson
May 14, 2025
The total weight of the Mec 2033ES with batteries is approximately 3815 lbs (1731 kg).
Need help?
Do you have a question about the 2033ES and is the answer not in the manual?
Questions and answers
need 2033 rear wheels to roll
To make the rear wheels of the Mec 2033ES roll:
1. Ensure wheels are chocked to prevent movement.
2. Open the tow valve by turning it. This manually releases the rear brakes.
3. The machine can then be winched or moved short distances at speeds not exceeding 5 mph (8.05 km/h).
This answer is automatically generated
Lift only goes up half way
The MEC 2033ES lift may only go up halfway due to several possible reasons:
1. Lift Capacity Exceeded – If the weight on the platform exceeds the rated capacity (800 lbs or 500 lbs, depending on the model), the lift may not fully extend.
2. Battery Charge Issue – If the battery is not sufficiently charged, the lift may not have enough power to reach full height. Check the battery charger LED indicators to confirm the charge level.
3. Hydraulic System Problem – A malfunction in the hydraulic manifold assembly, such as a faulty relief valve, spool valve, or coil, could limit the lift’s movement.
4. Preventive Maintenance Needed – If maintenance has not been performed at the recommended intervals, defects or malfunctions could prevent full extension.
5. Defective or Malfunctioning Component – Any defect in the lift system should be reported and repaired before further use, as operation with a defect can cause injury or system failure.
A qualified technician should inspect the lift to identify and fix the exact issue before continued use.
This answer is automatically generated
what is total weight w batteries
The total weight of the Mec 2033ES with batteries is approximately 3815 lbs (1731 kg).
This answer is automatically generated