Pre-Start Inspection Checklist; 30-Day Service; Frequent Inspection Checklist; Hydraulic Fluid - Mec 1330SE Service And Parts Manual

P -S I
RE TART
Items on this checklist should be inspected before each work shift. Refer to the
Operator's Manual.
30-D S
AY ER VICE
The 30 day maintenance procedure is a one-time procedure to be performed after the
first 30 days or 40 hours of usage. This procedure is normally performed every 150
hours or quarterly, whichever comes first.
Maintaining the tires and wheels in good condition is essential to safe operation and
good performance. Tire and/or wheel failure could result in a machine tip-over.
Component damage may also result if problems are not discovered and repaired in a
timely fashion.
1. Check the tire surface and sidewalls for cuts, cracks, punctures and unusual wear.
2. Check each wheel for damage, bends and cracks.
3. Remove the wheel covers and check each center lock nut for proper torque.
Castle nut torque, dry
Castle nut torque, lubricated
F I
REQUENT NSPECTION
THIS CHECKLIST MUST BE USED AT 3-MONTH INTERVALS OR EVERY
150 HOURS OF MACHINE USE, WHICHEVER OCCURS FIRST. FAILURE TO
DO SO COULD RESULT IN DEATH OR SERIOUS INJURY.
Frequent Maintenance Inspections should be conducted by qualified service
technicians only. Photocopy the Frequent Inspection Checklist page from the
Operator's Manual to keep record of this inspection. Keep inspections records up to
date. Record and report all discrepancies to your supervisor.
Perform all checks listed on Pre-Start Inspection, then proceed with the following
checks.
H
Y D R A U L I C
Inspect the condition of hydraulic fluid in the reservoir.
Oil should be a clear and amber in color.
C
NSPECTION
19 ft-Ibs / 26 Nm
14 ft-Ibs / 20 Nm
C
HECKLIST
F
L U I D
"1330SE" Service and Parts Manual
P
HECKLIST
- S I
R E T A R T N S P E C T I O N
C
H E C K L I S T
July 2017
Page 1-3