HEIDENHAIN TNC 620 User Manual page 96

3
Programming: Fundamentals, file management
3.2 Opening programs and entering
Possible feed rate input
Functions for setting the feed rate
Rapid traverse, non-modal. Exception: If
defined before an APPR block, FMAX is also
in effect for moving to an auxiliary point
(See "Important positions for approach and
departure", page 193)
Traverse feed rate automatically calculated in
TOOL CALL
Move at the programmed feed rate (unit of
measure is mm/min or 1/10 inch/min). With
rotary axes, the TNC interprets the feed rate
in degrees/min, regardless of whether the
program is written in mm or inches
Define the feed per revolution (units in mm/
rev or inch/rev). Caution: In inch-programs, FU
cannot be combined with M136
Define the tooth feed (units in mm/tooth or
inch/tooth). The number of teeth must be
defined in the tool table in the CUT. column
Functions for conversational guidance
Ignore the dialog question
End the dialog immediately
Abort the dialog and erase the block
96
Soft key
Key
NO
ENT
HEIDENHAIN Conversational Programming | 3/2014
TNC 620 | User's Manual