Automatic Program Start; Application - HEIDENHAIN TNC 620 User Manual

16
Test run and program run

16.6 Automatic program start

16.6 Automatic program start

Application

The TNC must be specially prepared by the machine
tool builder for use of the automatic program start
function. Refer to your machine manual.
Caution: Danger for the operator!
The autostart function must not be used on
machines that do not have an enclosed working
space.
In a Program Run operating mode, you can use the AUTOSTART
soft key (see figure at upper right) to define a specific time at which
the program that is currently active in this operating mode is to be
started:
Show the window for entering the starting time
(see figure at center right)
Time (hrs:min:sec): Time of day at which the
program is to be started
Date (DD.MM.YYYY): Date on which the program
is to be started
To activate the start, press the OK
526
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014