HEIDENHAIN TNC 620 User Manual page 596

18
Tables and overviews
18.5 Functions of the TNC 620 and the iTNC 530 compared
M Effect
M114 Automatic compensation of machine geometry when working
with tilted axes
M115 Reset M114
M116 Feed rate on rotary tables in mm/min
M117 Reset M116
M118 Superimpose handwheel positioning during program run
M120 Pre-calculate the radius-compensated contour (LOOK AHEAD)
Contour filter
M124
M126 Shorter-path traverse of rotary axes:
M127 Reset M126
M128 Maintaining the position of the tool tip when positioning with
tilted axes (TCPM)
M129 Reset M128
M130 Within the positioning block: Points are referenced to the
untilted coordinate system
M134 Exact stop at nontangential contour transitions when
positioning with rotary axes
M135 Reset M134
M136 Feed rate F in millimeters per spindle revolution
M137 Reset M136
M138 Selection of tilted axes
Retraction from the contour in the tool-axis direction
M140
M141 Suppress touch probe monitoring
M142 Delete modal program information
Delete basic rotation
M143
M144 Compensating the machine's kinematic configuration for
ACTUAL/NOMINAL positions at end of block
M145 Reset M144
M148 Automatically retract tool from the contour at an NC stop
M149 Reset M148
M150 Suppress limit switch message
M197 Rounding the corners
Laser cutting functions
M200
-M204
596
TNC 620
–
(recommended:
M128, TCPM)
X, option #08
X, option 21
X, option 21
– (possible
via user
parameters)
X
X, option #09
X
–
X
X
X
X
–
X
X, option #09
X
– (possible via
FN 17)
X
–
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
iTNC 530
X, option #08
X, option #08
X
X
X
X
X, option #09
X
X
X
X
X
X
X
X
X, option #09
X
X
–
X