HEIDENHAIN TNC 620 User Manual page 180

5
Programming: Tools
5.2 Tool data
Column
WTIME
RAD
BLOCK
PATH
T
OVRMAX
OVRMIN
NAMEPROG
There are two ways to run a tool usage test for a pallet file:
The highlight in the pallet file is on a pallet entry: The TNC runs
the tool usage test for the entire pallet
The highlight in the pallet file is on a pallet entry: The TNC runs
the tool usage test for the entire pallet
180
Meaning
Tool-usage time in seconds (total usage
time between tool changes)
Tool radius R + Oversize of tool radius
DR from the tool table. (in mm)
Block number in which the TOOL CALL
block was programmed
TOKEN = TOOL: Path name of the active
main program or subprogram
TOKEN = STOTAL: Path name of the
subprogram
Tool number with tool index
Maximum feed rate override that occurred
during machining. During Test Run the
TNC enters the value 100 (%)
Minimum feed rate override that occurred
during machining. During Test Run the
TNC enters the value –1
0: The tool number is programmed
1: The tool name is programmed
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014