HEIDENHAIN TNC 620 User Manual page 553

Option Meaning
Method Under
the service should not be available to
anyone
(Permit
(Permit some). If you set
you must also specify the computer (under
Computer) that you wish to grant access
to the respective service. If you do not
specify any computer under Computer,
the setting
automatically when the configuration is
saved.
Log If
Log
output if a network package for this service
was blocked. A "blue" message is output
if a network package for this service was
accepted.
Computer If the setting
under Method, the relevant computers
can be specified here. The computers can
be entered with their IP addresses or host
names separated by commas. If a host
name is used, the system checks upon
closing or saving of the dialog whether
the host name can be translated into an
IP address. If this is not the case, the user
receives an error message and the dialog
box is not closed. If you enter a valid host
name, this host name will be translated
into an IP address upon every startup of
the control. If a computer that was entered
with its name changes its IP address, you
may have to restart the control or formally
change the firewall configuration to ensure
that the control uses the new IP address
for a host name in the firewall.
Advanced These settings are only intended for your
options network specialists.
Set standard Resets the settings to the default values
values recommended by HEIDENHAIN
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
Method you can configure whether
(Prohibit all), available to everyone
all) or only available to some
Permit some
will become active
Prohibit all
is activated, a "red" message is
Permit some is selected
Firewall 17.12
553
17