Speed Of The Setting Test Runs - HEIDENHAIN TNC 620 User Manual

Hide thumbs Also See for TNC 620:

Table of Contents

Graphics (Advanced Graphic Features software option) 16.1

Speed of the Setting test runs

The most recently set speed stays active until a

power interruption. After the control is switched on

the speed is set to FMAX.

After you have started a program, the TNC displays the following

soft keys with which you can set the simulation speed:

Perform the test run at the same speed at which

the program will be run (programmed feed rates

are taken into account)

Increase the simulation speed incrementally

Decrease the simulation speed incrementally

Test run at the maximum possible speed (default

You can also set the simulation speed before you start a program:

Select the function for setting the simulation

Select the desired function by soft key, e.g.

incrementally increasing the simulation speed

TNC 620 | User's Manual

HEIDENHAIN Conversational Programming | 3/2014