Optional Block Skip 16.7; Application; Inserting The "/" Character; Erasing The "/" Character - HEIDENHAIN TNC 620 User Manual

16.7 Optional block skip

Application

In a test run or program run, the control can skip over blocks that
begin with a slash "/":
To run or test the program without the blocks
preceded by a slash, set the soft key to ON
To run or test the program with the blocks
preceded by a slash, set the soft key to OFF
This function does not work for TOOL DEF blocks.
After a power interruption the TNC returns to the
most recently selected setting.

Inserting the "/" character

In the Programming mode you select the block in which the
character is to be inserted
Select the INSERT soft key

Erasing the "/" character

In the Programming mode you select the block in which the
character is to be deleted
Select the REMOVE soft key
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014

Optional block skip 16.7

16
527