HEIDENHAIN TNC 620 User Manual page 253

Filter settings
After you have used the quick selection function to mark hole
positions, a pop-up window appears in which the smallest diameter
found is to the left and the largest diameter to the right. With the
buttons just below the diameter display you can adjust the smallest
diameter in the left area and largest in the right area so that you can
load the hole diameters that you want.
The following buttons are available:
Filter setting of smallest diameter
Display the smallest diameter found (default
setting)
Display the next smaller diameter found
Display the next larger diameter found
Display the largest diameter found. The TNC
sets the filter for the smallest diameter to the
value set for the largest diameter
Filter setting of largest diameter
Display the smallest diameter found. The TNC
sets the filter for the largest diameter to the
value set for the smallest diameter
Display the next smaller diameter found
Display the next larger diameter found
Display the largest diameter found (default
setting)
With the apply path optimization option on (default setting), the
TNC sorts the selected machining positions for the most efficient
possible tool path. You can have the tool paths displayed by clicking
the "Show tool path" icon, See "Basic settings", page 240.
TNC 620 | User's Manual
HEIDENHAIN Conversational Programming | 3/2014
Processing DXF Files (Software Option)
Button
Button
7
7.1
253