YASKAWA PROFINET V1000 Technical Manual page 25

29.
Reattach the front cover of the drive using four screws (see
tightening torque specifications.
NOTICE: Damage to Equipment. Take proper precautions when wiring the option so that the front covers will easily fit back onto the
drive. Make sure no cables are pinched between the front covers and the drive when replacing the cover. Failure to comply may result
in damage to circuitry and equipment.
Figure 30
Table 9 IP66/UL Type 4X Front Cover Installation Screw Size and Tightening Torque
Voltage Class
Single Phase 200 V Class
Three Phase 200 V Class
Three Phase 400 V Class
30.
For IP66/UL Type 4X enclosure models, go to Step
31.
For IP20/Open-Chassis or IP20/UL Type 1 enclosure models, attach the option cover by aligning the tabs with
the mounting holes, seat the front cover into place, and tighten the screw on the front.
Figure 31
Note: Take proper precautions when wiring the option so that the front covers will easily fit back onto the drive. Make sure no cables
are pinched between the front covers and the drive when replacing the covers.
32.
Set drive parameters in
YASKAWA ELECTRIC SIEP C730600 70B V1000 Option SI-EP3/V Technical Manual
Figure 30 Attach the Front Cover
Model No. CIMR-V
BA0001 to BA0012
2A0001 to 2A0020
2A0030 to 2A0069
4A0001 to 4A0011
4A0018 to 4A0038
Figure 31 Attach the Option Cover
Table 10 for proper option performance.
Figure 30). Refer to
V1000
Front cover screw
Front cover
Installation
Screw Size
M5
M5
M6
M5
M6
32. on page 25.
Line up tabs
5 Installation Procedure
Table 9 on page 25 for
Tightening Torque
Nm
(lb-in)
2.0 to 2.5 (17.7 to 22.1)
2.0 to 2.5 (17.7 to 22.1)
5.4 to 6.0 (47.8 to 53)
2.0 to 2.5 (17.7 to 22.1)
5.4 to 6.0 (47.8 to 53)
V1000
25