YASKAWA PROFINET V1000 Technical Manual page 17

7.
For models CIMR-VBA0001F to BA0003F, 2A0001F to 2A0006F, loosen the screws attaching the conduit
bracket to the drive to remove the conduit bracket.
Figure 11
8.
On UL Type 1 enclosure models (CIMR-VBA0001F to BA0003F, 2A0001F to 2A0006F), the screw for the drive
ground terminal also acts as one of the screws that attaches the conduit bracket to the drive. Reattach the
conduit bracket according to
terminal.
Note: The four different ground wires packaged with the option connect the option to different drive models. Select the proper ground
wire depending on drive size. Refer to
Figure 12
Figure 12 Reattach the UL Type 1 Conduit Bracket and Connect the Ground Wire for models
9.
For IP20/UL Type 1 enclosure models, go to Step
YASKAWA ELECTRIC SIEP C730600 70B V1000 Option SI-EP3/V Technical Manual
V1000
Figure 11 Remove the UL Type 1 Conduit Bracket
Figure 12 and connect the drive-side of the ground wire to the drive ground
Table 7 on page
V1000
Drive ground terminal/
conduit bracket screw
CIMR-VBA0001F to BA0003F, 2A0001F to 2A0006F
16 for ground wire selection by drive model.
Option
connector
Screw size: M3
Ground terminal
Ground wire
17. on page 21.
5 Installation Procedure
Drive-side
connector
Screw size:
M3.5 to M6
Ground wire
17