Mitsubishi Melservo-J2-Super series Instruction Manual page 81

5. PARAMETERS
Class No. Abbreviation
23 OP1 Optional function 1:
The parameter marked is valid only at power-on.
Select the optional function 1.
Serial encoder cable selection
Select the communication systems of CH1 (for motor) and CH2 (for full
closed encoder).
Hundreds
digit setting
0
1
2
Name
Servo forced stop selection
Select the servo forced stop function of the CN3-20 input.
0: Valid (forced stop signal is used)
1: Invalid (forced stop signal is not used)monitor ch1.
When full closed function
is invalid
(Pr. 62: 0)
ENC CH1 ENC CH2
2 wire type Unusable
4 wire type Unusable
2 wire type Unusable
5 - 4
Initial Value Unit
0000
When full closed function
is valid
(Pr. 62: 1 or 2)
ENC CH1 ENC CH2
2 wire type 2 wire type
4 wire type Unusable
2 wire type 4 wire type
Setting
Range
0000h
to
0201h