Mitsubishi Melservo-J2-Super series Instruction Manual page 45

2. LINEAR SCALES
Connection cable connection example (2)
The following cable wiring example assumes that the linear encoder (linear scale) is connected to CN2 of
the servo amplifier using the option cable MR-J2SCLCBL02M-P-H.
(1) Connection example of up to 30m wiring length (This connection example assumes that the following
operating combination is satisfied.)
[Operating combination]
Used Wire Size
AWG28
[Connection example]
Option cable
Servo amplifier
(MR-J2SCLCBL02M-P-H)
MR-J2S- B
-PY096/S096 To CN2
[Linear encoder side connector] (Note 4)
Applicable 10114-3000PE, 10314-52F0-008
Housing
OV
MR
MRR
SHD
Note 1. Do not connect the linear encoder (linear scale) that is not indicated in this specification.
2. Connect the shield wire to the plate (ground plate) in the connector securely.
3. For the wiring to the servo motor, refer to the standard connection examples in Chapter 3 and the Instruction Manual of the MR-
J2S- B standard model.
4. Contact the scale manufacturer for detailed specifications such as the combinations, models, types, etc. of the linear encoder
(linear scale) side output cable and connector.
Interpolator Model
MJ830
Servo motor
(Note 3)
10120-3000PE, 10320-52F0-008
(3M make or equivalent)
Linear
scale
connector
12 LG
11 LG
7 MR
17 MRR
Plate
SD
(Note 2)
30m or less
3M or Equivalent
11, 12
4
5
7
LG
LG
MR
MRR
SHD
Stabilized
power supply
(5V)
2 - 26
(Note 1)