Run The System Configuration Utility (Scu) - Digital Equipment DIGITAL Server 7100 1200 Service Maintenance Manual

11. If applicable, replace the video expansion board.
12. Install the left side panel and lock the server. The server will not power up
with the side panel removed.
13. Connect any cables and power cords previously removed to the back of the
server.

Run the System Configuration Utility (SCU)

Power up and boot the server from the SCU diskette. The SCU allows checking or
changing the server's configuration. Run the SCU to configure the server for the new
processor module.
To start and run the SCU:
1. Insert the SCU diskette into drive A and turn on the server. The diskette
should boot automatically.
2. When the SCU title appears, press any key to continue. Afterwards, follow
instructions to access the SCU main menu.
3. From the main menu, press the up or down arrow to highlight an item and
then press Enter to select it. Press F1 at any time for help about a selection.
4. From the main menu select Configure Computer and then View and
Edit Details. Example:
5. If a video option card is installed, select the Advanced Control Group
and disable the Embedded - PCI VGA controller.
6. Select Save and Exit to configure the server for the CPU module.
7. When complete, remove the SCU diskette from drive A.
8. Move the video cable to the newly installed video card and reboot the server.
Refer to Chapter 2, "Server Software and Utilities," in the System Reference
manual for additional information on the SCU.
Processor Module Upgrades
6-17