Installing A Second Processor Module - Digital Equipment DIGITAL Server 7100 1200 Service Maintenance Manual

Installing a Second Processor Module

To install a second processor module:
1. Shut down the operating system software.
2. Turn off your server.
3. Disconnect all external devices, ac power, and monitor power.
4. Unlock and remove the left side panel.
5. Carefully remove the terminator from the second processor module location
and place in an antistatic package (see Figure 6-1).
6. Remove the processor module, two regulators, and retaining bracket from
the antistatic package. Check switch J19 on the processor module for the
appropriate switch settings.
Refer to Chapter 5, "FRU Replacement," for switch descriptions and locations.
Processor Module Upgrades
6-5