Parameter Clear / All Parameter Clear - Mitsubishi Electric FR-HC2-7.5K Instruction Manual

Parameter clear / All parameter clear

3.5

Parameter clear / All parameter clear

POINT
 Set "1" to Pr. CL Parameter clear, ALLC All parameter clear to initialize all parameters. (Parameters are not cleared when
Pr. 77 Parameter write selection = "1".)
 Refer to the parameter list on page 188 for parameters cleared with this operation.
Operation
1.
Screen at power-ON
The monitor display appears.
2.
Press to choose the parameter
setting mode.
3.
Turn until "
4.
Press to read the currently set value.
" "(initial value) appears.
5.
Turn to change it to the setting value
" ".
6.
Press to set.
NOTE
 Converter operation stops during parameter clear and all parameter clear.
 After the clear, the converter starts with the initial parameter settings.
120
( ) " appears.
· Turn to read another parameter.
· Press to show the setting again.
· Press twice to show the next parameter.
Display
Parameter clear
Flicker ··· Parameter setting complete!!
The parameter
number read
previously appears.
All parameter clear
Parameter clear All parameter clear