Table of Contents
Advertisement
Description of parameters
3.4.15 Free parameter (Pr. 58, Pr. 59)
You can input any number within the setting range of 0 to 9999.
For example, the number can be used:
As a unit number when multiple units are used.
As a pattern number for each operation application when multiple units are used.
As the year and month of introduction or inspection.
Parameter
Number
58
Free parameter 1
59
Free parameter 2
REMARKS
Pr. 58 and Pr. 59 do not influence the operation of the converter.
3.4.16 Key lock selection of operation panel(Pr. 61)
Key operation of the operation panel can be disabled.
Parameter
Number
61
Key lock operation selection
Setting dial and key operation can be set invalid to avoid unintended changes to parameters.
Set "10" to Pr. 61, and hold
monitor display.
When the setting dial and key operation are invalid,
attempted while dial and key operation is invalid,
performed for 2s, the monitor display appears.)
To make the setting dial and key operation valid again, press
REMARKS
Even when the setting dial and key operation are invalid, reset by
Switching of monitor is not available.
NOTE
Release the operation lock to release the PU stop by key operation.
90
Name
Initial value
9999
9999
Name
Initial value
for 2s to make the setting dial and key operation invalid and to change the display to the
Setting range
0 to 9999
Desired values can be input. Data is held
even if the converter power is turned OFF.
0 to 9999
Setting range
0
0
10
appears on the operation panel. If dial or key operation is
appears. (When the setting dial or key operation is not
for 2s.
at a converter trip is still valid.
Description
Description
Key lock invalid
Key lock valid
Advertisement
Table of Contents
