Mitsubishi Electric FR-HC2-7.5K Instruction Manual page 129

Parameter copy and parameter verification
appears... Why?
appears... Why?
and
Appears when parameters are copied between the converter of
1. Set "0" (initial value) in Pr. 0 Simple mode selection.
2. Set the following setting (initial value) in Pr. 989 Parameter copy alarm release.
Pr. 989 Setting
3. Reset Pr. 50 to Pr. 57.
(2) Parameter verification
Whether the same parameter values are set in other converters or not can be checked.
1.
Move the operation panel to the
converter to be verified.
2.
Screen at power-ON
The monitor display appears.
3.
Press
setting mode.
4.
Turn until
appears.
5.
Press
value.
" "(initial value) appears.
6.
Turn to change it to the set value
" "(parameter copy verification mode).
7.
Press
of the verified inverter to the operation panel.
• If different parameters exist, different
parameter numbers and
• Hold down
8.
It there is no difference, "
flicker to complete verification.
REMARKS
If a model other than the FR-HC2 series is verified, "model error (
122
Parameter read error. Perform operation from step 3 again.
Parameter write error. Perform operation from step 8 again.
flicker alternately
55K
or lower
10
Operation
to choose the parameter
(parameter copy)
to read the currently set
to read the parameter setting
flicker.
to verify.
" and "
55K or lower and
75K
or higher
100
Display
"
Flicker ··· Parameter verification complete!!
)" appears.
75K or higher.
The parameter
number read
previously appears.
Flickers for about 30s
Flickering