Lisp Mobility - Cisco Nexus 7000 Series Command Reference Manual

lisp mobility

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
lisp mobility
To configure an interface on an ingress tunnel router (ITR) to participate in Locator/ID Separation
Protocol (LISP) VM mobility (dynamic-endpoint identifier (EID) roaming) for a specific dynamic-EID
policy, use the lisp mobility command. To remove this functionality, use the no form of this command.
Syntax Description dynamic-EID-polic-
name
Disabled
Defaults
Interface configuration mode
Command Modes
network-admin
Supported User Roles
vdc-admin
Command History Release
5.0(1.13)
In order for an interface on an xTR to participate in LISP VM mobility (dynamic-EID roaming), it must
Usage Guidelines
be associated by name with a specific LISP dynamic-EID roaming policy. A LISP dynamic-EID roaming
policy is configured by using the lisp dynamic-eid command. This policy is then associated with an
interface when you enter the lisp mobility dynamic-eid-policy-name command, where the
dynamic-eid-policy-name provides the association.
When a packet is received on an interface configured for LISP VM mobility, the packet is considered a
candidate for LISP VM mobility (dynamic-EID roaming) and its source address is compared against the
EID-prefix in the database-mapping entry (or entries) included as part of the specific lisp dynamic-eid
policy. If there is a match, the rules associated with LISP dynamic-EID roaming are applied. If there is
no match, the packet is forwarded natively (that is not LISP encapsulated).
You can apply multiple lisp mobility commands that refer to different dynamic-EID-policy-name
instances to the same interface. Packets received on the interface are compared against all policies until
a match is found or the packet discarded.
Cisco Nexus 7000 Series NX-OS LISP Command Reference
LSP-142
lisp mobility dynamic-EID-policy-name
no lisp mobility dynamic-EID-policy-name
Name of the LISP dynamic-EID policy to apply to this interface.
Modification
This command was introduced.
Cisco Nexus 7000 Series LISP Commands