Cisco Nexus 7000 Series Command Reference Manual page 54

ip lisp itr map-resolver
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
This example shows how to configure an ITR to use the Map-Resolver when sending its Map-Request
Examples
messages:
switch# configure terminal
switch(config)# ip lisp itr map-resolver 10.1.1.1
switch(config)# ip lisp itr map-resolver 2001:db8:0a::1
Related Commands Command
ip lisp alt-vrf
ip lisp itr
ip lisp
map-request-source
Cisco Nexus 7000 Series NX-OS LISP Command Reference
LSP-44
Description
Configures which VRF that LISP should use when sending Map Requests
for an IPv4 EID-to-RLOC mapping directly over the ALT.
Configures the Cisco NX-OS device to act as an IPv4 LISP Ingress Tunnel
Router (ITR).
Configures the source IPv4 or IPv6 address to be used in IPv4 LISP
Map-Request messages.
Cisco Nexus 7000 Series LISP Commands