Cisco Nexus 7000 Series Command Reference Manual page 108

ipv6 lisp itr send-data-probe
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
This example shows how to configure a LISP ITR to send Data Probes to determine IPv6 EID-to-RLOC
Examples
mappings:
switch# configuration terminal
switch(config)# ipv6 lisp itr send-data-probe
Related Commands Command
ipv6 lisp alt-vrf
ipv6 lisp itr
map-resolver
Cisco Nexus 7000 Series NX-OS LISP Command Reference
LSP-98
Description
Configures which VRF that LISP should use when sending Map Requests
for an IPv6 EID-to-RLOC mapping directly over the ALT.
Configured the IPv4 or IPv6 locator address of the LISP Map-Resolver to
which the ITR sends IPv6 Map-Request messages.
Cisco Nexus 7000 Series LISP Commands