show ipv6 lisp translation-cache
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
show ipv6 lisp translation-cache
To display the Locator/ID Separation Protocol (LISP) IPv6 address translation cache and statistics
associated with each entry, use the show ipv6 lisp translation-cache command.
Syntax Description
non-routable-EID
None
Defaults
Any command mode
Command Modes
network-admin
Supported User Roles
network-operator
vdc-admin
vdc-operator
Command History
Release
5.0(1.13)
The show ipv6 lisp translation-cache command is applicable only when the ipv6 lisp translate
Usage Guidelines
command is used to configure LISP translation.
When you use the non-routable-EID argument, only the statistics that are associated with that single
translation are displayed.
This command does not require a license.
This example shows how to display the LISP IPv6 address translation cache and statistics associated
Examples
with each entry:
switch# show ipv6 lisp translate-cache
LISP EID Translation Cache for VRF "default" - 1 entries
Inside: 2001:db8:aa::1 outside: 2001:db8:bb::1, ingress/egress count: 0/0
Last ingress packet: never, last egress packet: never
switch#
Related Commands
Command
show ipv6 lisp
Cisco Nexus 7000 Series NX-OS LISP Command Reference
LSP-182
show ipv6 lisp translation-cache [non-routable-EID]
(Optional) IPv4 address of the inside nonroutable EID.
Modification
This command was introduced.
Description
Displays the IPv6 LISP configuration status for the local device.
Cisco Nexus 7000 Series LISP Commands