Cisco Nexus 7000 Series Command Reference Manual page 84

ip lisp translate
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
This command does not require a license.
This example shows how to configure LISP to translate the inside address to the outside address:
Examples
switch# configure terminal
switch(config)# ip lisp translate inside 192.168.10.1 outside 10.1.10.1
Related Commands Command
ip lisp etr
ip lisp itr
ip lisp proxy-itr
Cisco Nexus 7000 Series NX-OS LISP Command Reference
LSP-74
Description
Configures the Cisco NX-OS device to act as an IPv4 LISP Egress Tunnel
Router (ETR).
Configures the Cisco NX-OS device to act as an IPv4 LISP Ingress Tunnel
Router (ITR).
Configures the Cisco NX-OS device to act as an IPv4 LISP Proxy Ingress
Tunnel Router (PITR).
Cisco Nexus 7000 Series LISP Commands