Roaming-Eid-Prefix - Cisco Nexus 7000 Series Command Reference Manual

roaming-eid-prefix

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
roaming-eid-prefix
To configure an optional endpoint identifier (EID) or list of EIDs to be considered as roaming
dynamic-EIDs, use the roaming-eid-prefix command. To remove this optional functionality, use the no
form of this command.
Syntax Description
eid-prefix
Specific (host-EID) prefixes within the dynamic-EID-prefix range specified in the database-mapping
Defaults
dynamic-EID subcommand are individually registered with the configured Map Server.
Dynamic-EID configuration mode
Command Modes
network-admin
Supported User Roles
vdc-admin
Command History Release
5.0(1.13)
Use the roaming-eid-prefix command to apply further restrictions on deciding which EIDs are t
Usage Guidelines
dynamic-EIDs and allowed to roam onto the interfaces that you configured when you entered the
matching dynamic-EID-policy-name by using the lisp mobility dynamic-EID-policy-name command.
When an EID is detected to be a candidate for dynamic-EID roaming and the optional
roaming-eid-prefix command is used, the EID must be covered by the roaming-eid-prefix entry in order
to be discovered. The EID-prefix listed in a database-mapping entry within the lisp dynamic-eid policy
is registered with the Map Server specified in the map-server command. That is, the
roaming-eid-prefix command restricts the discovery aspect of LISP VM Mobility (dynamic-EID
roaming) for initiating Map-Server registration.
Without this command, any EID within the EID-prefix range configured via the database-mapping entry
Note
is discovered and registered.
The EID referenced by the roaming-eid-prefix command can be either an IPv4 or IPv6 address in the
EID space.
This command does not require a license.
Cisco Nexus 7000 Series NX-OS LISP Command Reference
LSP-154
roaming-eid-prefix eid-prefix
no roaming-eid-prefix eid-prefix
IPv4 or IPv6 EID-prefix allowed to be considered as dynamic-EIDs (roaming).
Modification
This command was introduced.
Cisco Nexus 7000 Series LISP Commands