Cisco Nexus 7000 Series Command Reference Manual page 88

ipv6 lisp alt-vrf
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
When you use the ip lisp alt-vrf command, the referenced VRF must already have been created by using
Note
the vrf context command. In addition, the corresponding configurations for connecting the LISP device
to the ALT, including the generic routing encapsulation (GRE) tunnel interface(s) and any routing that
is associated with the VRF (static or dynamic) you must also have created.
This example shows how to configure the VRF named lisp and then configure LISP to use this VRF
Examples
when resolving IPv6 EID-to-RLOC mappings:
switch# configure terminal
switch(config)# vrf context lisp
switch(config-vrf)# exit
switch(config)# ipv6 lisp alt-vrf lisp
Related Commands Command
ipv6 lisp itr
map-resolver
ipv6 lisp itr
ipv6 lisp pitr
Cisco Nexus 7000 Series NX-OS LISP Command Reference
LSP-78
virtualized LISP deployment, you must configure the PITR to use a Map-Resolver for
EID-to-RLOC mapping resolution, not the LISP ALT because the LISP ALT does not support
virtualization.
Description
Configures the locator address of the LISP Map-Resolver to which the ITR
sends Map-Request messages.
Configures the Cisco NX-OS device to act as a LISP Ingress Tunnel Router
(ITR).
Configures the Cisco NX-OS device to act as a LISP Proxy Ingress Tunnel
Router (PITR).
Cisco Nexus 7000 Series LISP Commands