Ipv6 Lisp Map-Resolver - Cisco Nexus 7000 Series Command Reference Manual

Cisco Nexus 7000 Series LISP Commands
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .

ipv6 lisp map-resolver

To configure a switch to act as an IPv6Locator/ID Separation Protocol (LISP) Map-Resolver (MR), use
the ipv6 lisp map-resolver command. To remove LISP Map-Resolver functionality, use the no form of
this command.
This command has no arguments or keywords.
Syntax Description
None
Defaults
Global configuration mode
Command Modes
network-admin
Supported User Roles
vdc-admin
Command History Release
5.0(1.13)
Use the ipv6 lisp map-resolver command to enable the Cisco NX-OS device to perform the IPv6 LISP
Usage Guidelines
Map-Resolver (MR) functionality. A LISP Map-Resolver is deployed as a LISP Infrastructure
component.
A Map-Resolver receives a LISP Encapsulated Control Message (ECM) that contains a Map-Request
from a LISP ITR directly over the underlying locator-based network. The Map-Resolver decapsulates
this message and forwards it on the LISP-ALT topology, where it is delivered either to an ingress tunnel
router (ITR) that is directly connected to the LISP-ALT and that is authoritative for the endpoint
identifier (EID) being queried by the Map-Request or to the Map-Server that is injecting EID-prefixes
into the LISP-ALT on behalf of the authoritative ETR.
OL-25345-01
ipv6 lisp map-resolver
no ipv6 lisp map-resolver
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS LISP Command Reference
ipv6 lisp map-resolver
LSP-111