Ipv6 Lisp Translate - Cisco Nexus 7000 Series Command Reference Manual

Cisco Nexus 7000 Series LISP Commands
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .

ipv6 lisp translate

To configure IPv6 Locator/ID Separation Protocol (LISP) translation mapping, use the ipv6 lisp
translate command. To remove IPv6 LISP translation mappings and return to the default value, use the
no form of this command.
Syntax Description
inside
IPv6-inside-EID
outside
IPv6-outside-EID
None
Defaults
Global configuration mode
Command Modes
network-admin
Supported User Roles
vdc-admin
Command History Release
5.0(1.13)
When you configure a LISP ITR or ETR with a nonroutable EID prefix and you want to replace it with
Usage Guidelines
a routable EID prefix, use the ipv6 lisp translate command. A LISP device that acts as an ITR and
detects a nonroutable EID in the source IPv4 address field replaces it with the routable EID when you
use the inside and outside keyword. In the opposite direction when acting as an ETR, it replaces the
routable EID referred to by the outside keyword with the no-routable EID referred to by the inside
keyword.
The outside EID address can be assigned to the Cisco NX-OS device itself, in which case it responds to
Note
ARP requests, ICMP echo-requests (ping) and any other packet sent to this address. When you do not
assign the outside EID to the device, the address does not answer ARP requests.
OL-25345-01
ipv6 lisp translate inside IPv6-inside-EID outside IPv6-outside-EID
no ipv6 lisp translate inside IPv6-inside-EID outside IPv6-outside-EID
Indicates that the inside (nonroutable) IPv6 endpoint identifier (EID) prefix
follows.
Nonroutable IPv6 address associated with an inside EID prefix.
Indicates that the outside (routable) IPv6 EID prefix follows.
Routable IPv6 address associated with an outside EID prefix.
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS LISP Command Reference
ipv6 lisp translate
LSP-125