Lisp Dynamic-Eid - Cisco Nexus 7000 Series Command Reference Manual

lisp dynamic-eid

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
lisp dynamic-eid
To configure a LISP VM Mobility (dynamic-EID roaming) policy and enter dynamic-EID configuration
mode on an xTR, use the lisp dynamic-eid command. To remove the LISP dynamic-EID policy, use the
no form of this command.
Syntax Description
dynamic-EID-policy
-name
None
Defaults
Global configuration mode
Command Modes
network-admin
Supported User Roles
vdc-admin
Command History Release
5.0(1.13)
To configure LISP VM-Mobility, you must create a dynamic-EID roaming policy that can be referenced
Usage Guidelines
by the lisp mobility dynamic-eid-policy-name interface command. When you enter the lisp dynamic-eid
dynamic-EID-policy-name command, the referenced LISP dynamic-EID policy is created and you are
placed in the dynamic-EID configuration mode. In this mode, you can enter all attributes associated with
the referenced LISP dynamic-EID policy.
In this release of LISP VM-Mobility, the following caveats apply:
Note
When a dynamic-EID is roaming across subnets, you must configure it with a /32 IP address and an
interface route to the default switch. For example, for a Linux or UNIX host, the following configuration
is used:
ifconfig eth0 eid-address netmask 255.255.255.255
route add default any-switch-address
route add default any-switch-address
When a dynamic-EID is roaming across subnets, you must configure it with a /32 IP address and an
interface route to the default switch. For example, for a Linux or UNIX host, the following configuration
will be used:
Cisco Nexus 7000 Series NX-OS LISP Command Reference
LSP-134
lisp dynamic-eid dynamic-EID-policy-name
no lisp dynamic-eid dynamic-EID-policy-name
Name of the LISP dynamic-EID policy.
Modification
This command was introduced.
Cisco Nexus 7000 Series LISP Commands