Ipv6 Lisp Hardware-Forwarding - Cisco Nexus 7000 Series Command Reference Manual

Cisco Nexus 7000 Series LISP Commands
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .

ipv6 lisp hardware-forwarding

To enable hardware-forwarding specifically on the Cisco Nexus 7000 Series switch when at least one
32x10GE line card is installed, use the ipv6 lisp hardware-forwarding command. To disable this
functionality, use the no form of this command.
This command has no arguments or keywords.
Syntax Description
Enabled when at least one 32x10 GE line card is installed.
Defaults
Global configuration mode
Command Modes
network-admin
Supported User Roles
vdc-admin
Command History Release
5.0(1.13)
This command is only applicable to the Cisco NX-OS device.
Usage Guidelines
The ip lisp hardware-forwarding command is applicable to the Cisco Nexus 7000 Series switch only.
Hardware forwarding for LISP is only supported on the N7K-M132XP-12 line card only. That is, LISP
input and output interfaces MUST be on the N7K-M132XP-12 line card.
Disabling hardware forwarding should only be used in diagnostic situations. Configuring the no ip lisp
Caution
hardware-forwarding command will cause a full map-cache download to the Cisco NX-OS device
hardware.
This command does not require a license.
This example shows how to disable the IPv6 LISP hardware forwarding feature:
Examples
switch# configure terminal
switch(config)# no ipv6 lisp hardware-forwarding
switch(config)# exit
OL-25345-01
ipv6 lisp hardware-forwarding
no ipv6 lisp hardware-forwarding
Modification
This command was introduced.
Cisco Nexus 7000 Series NX-OS LISP Command Reference
ipv6 lisp hardware-forwarding
LSP-91