Ip Lisp Hardware-Forwarding - Cisco Nexus 7000 Series Command Reference Manual

ip lisp hardware-forwarding

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
ip lisp hardware-forwarding
To enable hardware-forwarding specifically on the Cisco Nexus 7000 Series switch when at least one
32x10GE line card is installed, use the ip lisp hardware-forwarding command. To disable
hardware-forwarding functionality, use the no form of this command.
This command has no arguments or keywords.
Syntax Description
Enabled
Defaults
Global configuration mode
Command Modes
network-admin
Supported User Roles
vdc-admin
Command History Release
5.0(1.13)
The ip lisp hardware-forwarding command is applicable to the Cisco Nexus 7000 Series switch only.
Usage Guidelines
Hardware forwarding for LISP is only supported on the N7K-M132XP-12 line card only. That is, LISP
input and output interfaces MUST be on the N7K-M132XP-12 line card.
Disabling hardware forwarding should only be used in diagnostic situations. Configuring the no ip lisp
Caution
hardware-forwarding command will cause a full map-cache download to the Cisco NX-OS device
hardware.
This command does not require a license.
This example shows how to disables IPv4 LISP hardware forwarding on the Cisco Nexus 7000 Series
Examples
switch:
switch# configure terminal
switch(config)# no ip lisp hardware-forwarding
switch(config)# exit
Cisco Nexus 7000 Series NX-OS LISP Command Reference
LSP-40
ip lisp hardware-forwarding
no ip lisp hardware-forwarding
Modification
This command was introduced.
Cisco Nexus 7000 Series LISP Commands