Belt Cleaning & Inspection; Calibration - Trackmaster FVX325 Field Service Manual

Interior cleaning
Tools Required
1. Turn the treadmill main power switch to the off position.
2. Unplug the Treadmill from the wall receptacle.
3. Allow treadmill to discharge for 3 minutes.
4. Slide the hood grommets up the center handrail approximately 2' only on TMX
Series on FVX Series set hood to side..
5. Remove the three hood securing bolts on the lower front end of treadmill.
6. Slide hood up treadmill center rail and force past the grommets, allow hood to
hang from grommets.
7. Clean Interior of motor pan by gently vacuuming (with hose attachment) any
foreign objects or debris.
8. Replace the hood and its bolts and slide the hood grommets back into place.
CAUTION: AVOID USING LIQUID CLEANERS
Belt Cleaning and Inspection
1. Turn treadmill main power switch ON.
2. Start treadmill at .5 mph
3 With a damp small towel wipe excessive dirt from running belt
4. When belt is clean stop treadmill.
5. Inspect belt for tear or nick to running belt. If DAMAGED replace belt.
6. Perform Belt tracking and Belt tension, see Section 4 for procedure

Calibration

1. Calibration procedures should be performed when on or more of the following
exist.
a. Replacement of Power Supply Relay Board
b. Replacement of Elevation Actuator
c. Replacement of Motor
d. Replacement of Inverter Drive
e. Improper Belt Speed or Elevation values has been detected
6-2
¼ inch hex nut driver or flat blade screwdriver
Vacuum with hose and attachments
FVX, TMX Series Service Manual
TRACKMASTER
August, 2006