Motor Drive Belt Replacement FVX Series
Tools required
1/4" Hex wrench or Hex socket
7/16" wrench or socket
9/16" Open-end wrench
1/4" Hex nut driver or flat blade screw driver
Approximate time to complete 1.5 hrs
1.
Elevate the treadmill to approximate 15% grade.
2.
Turn the treadmill main power switch to the off position.
3.
Unplug the Treadmill from the wall receptacle.
4.
Remove the three hood securing bolts on the lower front end of treadmill.
5.
Set hood to the side of treadmill.
6.
Loosen 4 Motor mounting nuts on underside of treadmill.
7.
Loosen 2 Motor tension adjustment nuts inside motor pan of treadmill allowing
motor to move closer towards the front roller.
8.
Loosen rear belt tension bolts allowing the rear roller to move forward towards
the front roller.
9.
Remove hex socket head cap screw retaining front roller on right hand side.
10.
Now lift right hand end of roller up enough to remove the drive belt.
11.
Reverse procedure to install new drive belt.
12.
After installation follow drive belt/run belt; see Chapter 4 for Running Belt
Tension Procedure and Drive Belt Tension Procedure.
8-20
FVX, TMX Series Service Manual
TRACKMASTER
August, 2006