Circuit Breaker Replacement - Trackmaster FVX325 Field Service Manual

Circuit Breaker Replacement

Tools required
1/4" Hex nut driver or flat blade screwdriver
3/32" flat blade electronics screwdriver
Approximate time to complete .25 hrs
1.
Elevate the treadmill to approximate 15% grade.
2.
Turn the treadmill main power switch to the off position.
3.
Unplug the Treadmill from the wall receptacle.
4.
Allow treadmill to discharge for 3 minutes.
5.
Remove the two screws retaining the circuit breaker mounting plate.
6.
Gently pull the plate out allowing wires to feed through the hole.
7.
Unplug the two wires off the circuit breaker to replace, when replacing more than
one; perform the replacement one at a time to keep the wires on the correct value
of circuit breaker.
8.
Using the small electrical flat blade screwdriver push the holding clips on the
sides of the breaker in to allow it to slide out of the plate. These are located on
the backside of the plate made as part of the breakers housing.
9.
Install the new circuit breaker by sliding it in the hole until it snaps into place.
10.
Reattach the wires by sliding them on the terminals.
11.
Once all desired breakers have been replaced reinstall the plate with the two
screws.
12.
After installation check the unit for proper operation.
8-30
FVX, TMX Series Service Manual
TRACKMASTER
August, 2006