Trackmaster FVX325 Field Service Manual page 132

TRACKMASTER
48 PROGRAM
SELECTION
50 FAULT HISTORY
51 SOFTWARE CODE
52 DC BUS VOLTAGE
53 MOTOR VOLTAGE
54 LOAD
55 0 -10 VDC INPUT
56 4 - 20 mA INPUT
57 TB STRIP STATUS
58 KEYPAD STATUS
59 TB 30 OUTPUT
60 TB 31 OUTPUT
NOTE 1: Factory defaults are shown for 60 Hz base frequency. See Parameter 48 for 50
Hz base frequency.
NOTE 2: Maximum setting is 999.9 Hz on drives with High Output Frequency option.
Consult factory
NOTE 3: If LINE VOLTAGE is set to LOW. Maximum setting is 150%.
NOTE 4: Maximum setting is 1300.0 Hz (factory default is 999.9) on drives with High
Output Frequency option.
NOTE 5: After the burn in, change # 27 to 50 Hz on the treadmills with European plugs.
•
Press Mode button, inverter readout displays 0.0
•
Press Up arrow until inverter readout displays 135
•
Press the Mode button, inverter readout displays P01
•
Press the Mode button to observe or change the value of P01 or press the Up arrow to
advance to P02. (Use the Up/Down arrows to change parameter values, press the Mode
button to return to the parameter number)
•
Once inspection or modification to values is complete, press the Mode button until the
inverter readout displays dashes, example (---)
The value at P01 is set to 01. Input power is assumed to be at 120 or 240 VAC level. If
Voltage level is actually below 120 or 240 VAC, change the value at P01 from 1 to 2.
August, 2006
USER SETTINGS (01), OEM SETTINGS (02)
, RESET OEM (03), RESET 60 (04). RESET
50 (05), TRANSLATE (06)
( VIEW ONLY)
( VIEW ONLY)
( VIEW ONLY)
( VIEW ONLY)
( VIEW ONLY)
( VIEW ONLY)
( VIEW ONLY)
( VIEW ONLY)
( VIEW ONLY)
(VIEW ONLY )
(VIEW ONLY)
FVX, TMX Series Service Manual
USER SETTINGS (01)
(N/A)
( N/A)
( N/A)
( N/A)
( N/A)
( N/A)
( N/A)
(N/A)
(N/A)
(N/A)
(N/A)
11-5