Lift The Server Into The Rack Cabinet - Fujitsu PRIMERGY CX400 M4 Upgrade And Maintenance Manual

Ê Release the positioning clip (1) after the designated position is reached.
Ê Move the left rail towards the front side (4) while holding the positioning clip
(3). The mounting aid must lock in the corresponding hole.
Ê Release the positioning clip (5) after the designated position is reached.
Figure 26: Tightening the M5 screw
Ê Tighten the M5 screw (6) on the front side of the rail.
Ê Repeat this procedure to install the right rail.

4.11.4 Lift the server into the rack cabinet

V
CAUTION!
At least two people are needed to position the server on the rack rails.
(For Japan, please refer to " 安全上のご注意 ".)
CX400 M4
Upgrade and Maintenance Manual
Basic hardware procedures
65