Replacing The Hdd/Ssd Bridge Board; Preliminary Steps - Fujitsu PRIMERGY CX400 M4 Upgrade And Maintenance Manual

Hard disk drives (HDD), solid state drives (SSD) and 2.5-inch PCIe-SSD
7.7

Replacing the HDD/SSD bridge board

Field Replaceable Unit
(FRU)
Tools: Preliminary and concluding steps: Phillips PH2 / (+) No. 2 hexagonal
cross SW5 / PZ2
Main steps: tool-less
7.7.1

Preliminary steps

Perform the following procedures:
Ê Shut down the server nodes as described in section
server node" on page
Ê Remove all HDD/SSD modules from the relevant HDD/SSD cage as
described in section
"Extending the server enclosure out of the rack" on page
Ê
"Opening the server enclosure" on page
Ê
Ê Remove all fan modules as described in section
on page 131.
"Removing the fan modules cage" on page
Ê
Ê Remove all HDD/SSD backplanes as described in section
2.5-inch HDD/SSD backplane" on page
"Removing the midplane kit" on page
Ê
114
40.
"Removing 2.5-inch HDD/SSD modules" on page
Upgrade and Maintenance Manual
Hardware: 40 minutes
"Shutting down the
50.
"Removing the fan module"
104.
105.
152.
98.
43.
"Removing the
CX400 M4