Henny Penny EVOLUTION ELITE EEG-241 Operator's Manual page 76

6-1.
SPECIAL PROGRAM
MODE
(CONT.)
March 2014
Usage Code Change (SP-26)
This allows the operator to change the reset usage code (factory set at 1,
2, 3) to reset the usage amounts of each product. See Review Usage step
in Information Mode.
Press ► button and "SP-26 CHANGE USAGE CODE? 1=YES"
•
flashes in the display. Press
P=DONE, I=QUIT show scrolls through display. Press product
buttons for new code.
If satisfied with code, press
•
P=DONE, I=QUIT" shows in display. Press same code buttons.
If satisfied with code, press
•
display.
If not satisfied with code, press
•
display, then reverts back to "SP-26" and "CHANGE, USAGE
CODE? 1=YES". Now the above steps can be repeated.
Dispose Requires Code ? (SP-27)
Press ► button and "SP-27 DISPOSE REQUIRES CODE ?"
•
flashes in the left display. Press the ▲ or ▼buttons to choose YES
or NO. If set to YES, code 1, 2, 3 must be entered to discard the oil
from the vat, using the Dispose Mode.
Longer Fill Time (SP-28)
Press ► button and "SP-28 LONGER FILLTIME ENABLED?"
•
flashes in the left display. Press the ▲ or ▼buttons to choose YES
or NO.
Let User Exit Fill (SP-29)
Press ► button and "SP-29 LET USER EXIT FILL" flashes in the
•
left display. Press the ▲ or ▼buttons to choose YES or NO. If YES
is chosen, the user can exit the Express Filter
Skip 'SKIM' Prompt (SP-30)
Press ► button and "SP-30 SKIP 'SKIM' PROMPT?" flashes in the
•
left display. Press the ▲ or ▼ buttons to choose YES or NO.
69
and "ENTER NEW CODE,
and "REPEAT NEW CODE,
"*CODE CHANGED*" shows in
and "*CANCEL" shows in
fill operation.
TM