Henny Penny EVOLUTION ELITE EEG-241 Operator's Manual page 80

7-1.
TROUBLE SHOOTING
GUIDE
(CONT.)
Problem
Oil foaming or boiling over
top of vat
Oil will not drain from vat
Filter motor runs but pumps
oil slowly
Bubbles in oil during entire
filtering process
Filter motor will not run
March 2014
Cause
• Water in oil
• Improper or bad oil
• Improper filtering
• Improper rinsing after
cleaning the vat
• Drain valve clogged with
crumbs
• Drain trough clogged
• Filter line connections loose
• Filter paper or pad clogged
• Filter not reassembled
correctly
• Filter pan not completely
engaged
• Filter pan clogged
• Damaged O-ring on filter line
receiver on fryer
• The thermal reset button on
the rear of the pump motor is
tripped
To prevent burns caused by
splashing shortening, turn
the unit's POWER switch
to the OFF position before
resetting the filter pump
motor's manual reset
protection device.
• Drain and clean oil
• Use recommended oil
• Refer to filtering procedures
• Clean and rinse vat and then dry thoroughly
• Open valve, force cleaning brush through
drain
• Remove right side panel and remove plug
from end of trough and clean trough
• Tighten all filter line connections
• Change filter paper or pad
• Refer to assembly instructions on inside door
• Make sure filter pan return line is pushed
completely into the receiver on the fryer
• Clean pan and change paper or pad
• Change O-ring
• Open the number two door from the right
side of the unit (operator's view) and
allow time for the motor to cool. Using a
screwdriver, press hard against the button
until it clicks
73
Correction