Oil Guardian™ (Auto Top-Off); Selecting Aproduct Witha Different Setpoint; Replacing The Jib - Henny Penny EVOLUTION ELITE EEG-241 Operator's Manual

3-7.
OIL GUARDIAN™
(AUTO TOP-OFF)
3-8.
SELECTING A
PRODUCT WITH
A DIFFERENT
SETPOINT
3-9.

REPLACING THE JIB

Figure 1
March 2014
During normal operation, the control automatically monitors vat oil
level. If the control senses oil level is too low, unit automatically pumps
oil from BIB into vat to keep oil at the proper level.
Manual Top-Off
If oil level is a little low, oil can be added to vat at any time from BIB
to raise oil level to the proper level by following steps below. This
procedure is NOT to be used to fill an empty vat.
Press and hold (either one-full vat) until display shows
1.
"*FILTER MENU*" followed by "1.EXPRESS FILTER".
Press ► 5 times until "6.FILL FROM BIB" shows in display.
2.
Press √ button, "FILL VAT" "√=PUMP" "X=DONE" is displayed.
3.
Press and hold √ button; display shows "FILLING" and oil is
4.
pumped from the BIB to the vat.
Once vat is full, release √ button, "FILL VAT" "√=PUMP"
5.
"X=DONE" displays. Press X button twice for normal operation.
When selecting a product, if "XXX XXX" shows in display, the setpoint
temperature is not correct for this product. To change the setpoint
temperature for the desired product:
Press product button, for ex:
1.
Display shows "XXX XXX".
2.
Press and hold a timer button
3.
"FRY" shows in display.
Allow oil temperature to reach setpoint temperature before dropping
4.
product.
Control displays "JIB IS LOW" and an alarm sounds.
1.
2.
Open right door, pull JIB from unit, pull cap from JIB top, discard
empty BIB, and replace with full one. Figure 1.
23
(FRY).
or for 5 seconds and then