Henny Penny EVOLUTION ELITE EEG-241 Operator's Manual page 75

6-1.
SPECIAL PROGRAM
MODE
(CONT.)
March 2014
Bulk Oil Supply (SP-22)
Press ► button and "SP-22 BULK OIL SUPPLY?" flashes in the
•
left display. Press the ▲ or ▼ buttons to choose "YES SUPL"
or "NO SUPL".
Set to YES if the oil is pumped into the vats from an outside oil
•
reservoir. Otherwise, set SP-22 to NO.
Bulk Oil Disposal (SP-23)
Press ► button and "SP-23 BULK OIL DISPOSE?" flashes
•
in the left display. Press the ▲ or ▼ buttons to choose "YES
DISP" or "NO DISP".
Set to "YES DISP" if the oil is pumped from the vats to an
•
outside oil reservoir when disarding the oil. Otherwise, set SP-
23 to "NO DISP".
Serial Number Log (SP-24)
Press ► button and "SP-24 S/N √EDIT" flashes in the displays,
•
along with the serial number of the unit. THIS SERIAL
NUMBER SHOULD MATCH THE SERIAL NUMBER ON
THE DATA PLATE, ON THE DOORS. IF NOT, IT CAN BE
RECORDED.
Program Code Change (SP-25)
This allows the operator to change the program code (factory set at
1, 2, 3) used to access Product Programming and Level 2 Program
Mode.
Press ► button and "SP-25 CHANGE MGR CODE? 1=YES"
•
flashes in the display. Press
P=DONE, I=QUIT scrolls through the display. Press the product
buttons for new code.
If satisfied with code, press
•
P=DONE, I=QUIT, shows in display. Press same code buttons.
If satisfied with code, press
•
shows in display.
If not satisfied with code, press
•
in display, then reverts back to "SP-25" and "CHANGE, MGR
CODE? 1=YES". Now the above steps can be repeated.
68
and "ENTER NEW CODE,
and "REPEAT NEW CODE,
and "*CODE CHANGED*"
and "*CANCEL" shows