Henny Penny EVOLUTION ELITE EEG-241 Operator's Manual page 67

5-1.
MODIFYING
PRODUCT SETTINGS
(CONT.)
March 2014
To Change Times and Temperatures
Press ► button until "COOK TIME" shows in the display, and then
7.
use the product buttons, or the ▲ and ▼ buttons, to change the time
in minutes and seconds, to a maximum of 59:59.
Press ► button and "TEMP" shows in the display, along with the
8.
preset temperature on the right side of the display.
Press the product buttons, or the ▲ and ▼ buttons, to change the
temperature. The temperature range is 190°F (88°C) to 375°F
(191°C).
Cook ID Change
Press ► button until "COOK ID" shows in the display along with
9.
the product ID. For example, NUG would be the ID for nuggets.
Use the product buttons, or the ▲ and ▼ buttons, to change the ID.
Alarms (1 & 2)
Press ► button until "ALRM 1" shows in the left display, and an
10.
alarm time in the right display. Press the product buttons, or the ▲
and ▼ buttons, to set an alarm.
Ex., If a Cook Cycle was set at 3 minutes, and an alarm was to go off
after 30 seconds into the Cook Cycle, "2:30" would be set in the display
at this time. When the timer counts down to 2:30 the alarm sounds.
After alarm time is set, press ▲ button and "ALRM 2" shows in
display, and a second alarm can be programmed.
Quality Timer (hold time)
Press ▲ button until "QUAL TMR" shows in the display along with
11.
the preset holding time. Press the product buttons, or the ▲ and ▼
buttons,to adjust holding time, up to 2 hours:59 minutes.
Global Filter Tracking
Include in Filter Count
A. Press ► button until "INCL IN FLTR CNT" flashes in display
12.
along with "YES" or "NO". Using ▲ and ▼buttons, change the
display to "YES" if that product's Cook Cycles are to be counted as
part of the recommended filter process. Set to "NO" if it is not to be
included.
Mixed Filter Tracking
Filter After X Number of Loads
B. Press ► button until "FILTER AFTER..." flashes in the left
12.
display along, and the number of cook cycles between filters shows
in the right display. Press the product buttons, or the ▲ and ▼
buttons, to change this value of 0 to 99 loads. This needs set for each
product.
60