Table of Contents
Advertisement
SuperStorage Server 6048-E1CR90L User's Manual
USB 3.0 Support
Select Enabled for USB 3.0 support. The options are Smart Auto, Auto, Enabled, and
Disabled.
SATA Configuration
When this submenu is selected, AMI BIOS automatically detects the presence of the SATA
devices that are supported by the Intel PCH chip and displays the following items:
SATA Controller
This item enables or disables the onboard SATA controller supported by the Intel PCH chip.
The options are Enabled and Disabled.
Configure SATA as
Select IDE to configure a SATA drive specified by the user as an IDE drive. Select AHCI to
configure a SATA drive specified by the user as an AHCI drive. Select RAID to configure a
SATA drive specified by the user as a RAID drive. The options are IDE, AHCI, and RAID.
*If the item above "Configure SATA as" is set to AHCI, the following items will display:
SATA Port 0~ Port 5
This item displays the information detected on the installed SATA drive on the particular
SATA port.
•
Model number of drive and capacity
•
Software Preserve Support
Port 0~ Port 5
Select Enabled to enable a SATA port specified by the user. The options are Disabled and
Enabled.
Port 0 ~ Port 5 Hot Plug
Select Enabled to enable hot-plugging for a port specified by the user, which will allow the
user to replace a SATA disk drive installed on this port without shutting down the system.
The options are Enabled and Disabled.
Port 0 ~ Port 5 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The
options are Enabled and Disabled.
Port 0 ~ Port 5 SATA Device Type
Use this item to specify if the SATA port specified by the user should be connected to a Solid
State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
*If the item above "Configure SATA as" is set to IDE, the following items will display:
88
Advertisement
Table of Contents
