Installing The Outer Rails Onto The Rack - Supermicro SuperStorage Server 6048R-E1CR90L User Manual

Installing the Outer Rails onto the Rack

The outer rail is actually two parts that slide to lengthen the rail. Each end of the assembled
outer rail includes a bracket with round pegs to fit into your rack holes. The left and right rail
and the front and rear of each rail is labeled.
1. Align the round pegs on the front end of the rail with the square holes on the front post
of the rack. Push the rail sideways firmly against the rack and toward the rear until
the quick release bracket snaps into place, securing the rail to the rack. Keep the rail
horizontal.
2. Adjust the rail to reach almost to the rear post of your rack making sure that rear
bracket is level with the front bracket.
3. At the rear of the rack, align the round pegs on the rear end of the rail to the holes on
the rack. Push and hold the latch lever toward the center of the rack while pulling the
pegs into the holes of the rack. Once the rail seats against the rack, release the latch
lever.
4. Use a screw to further secure the rail rear to the rack.
Latch Lever Handle
4
Figure 2-4. Installing the Outer Rails to the Rack
3
(left rail shown)
23
Chapter 2 Installation in a Rack
1