Table of Contents
Advertisement
Connector
Description
Battery (BT1)
Onboard CMOS battery (See Chpt. 3 for Used Battery Disposal)
COM1/COM2
Backplane COM port (COM1)/4-pin onboard serial port header (COM2)
JF1
Front Panel Control connector
JL1
Chassis intrusion header
JPSB
Power distribution board header (Part No: PDB-PT946-S386)
JPW1/2
12V 8-pin power connectors
JPW3_STBY
8-pin power connector for onboard 12V power and 12V standby power
JPW_HDD
4-pin (+5V/+12V) power connector for HDD use
JSAS
SAS 3008 add-on module connector used for SAS expanders (Part No: AOC-SAS3-
946E90)
JSIOM
Supermicro I/O module connector (SIOM) for SIOM card use
JSPK1
Internal speaker/buzzer
JTPM1
TPM (Trusted Platform Module)/Port 80 header
IPMI_LAN
IPMI_dedicated LAN support by the ASpeed AST2400 controller
I-SATA 0-3
I-SATA 3.0 connections (0-3) supported by Intel PCH (I-SATA1 & I-SATA 3 support
SMCI SuperDOM connections w/power pins built-in)
SFP/LAN1-SFP/LAN4
10G SFP (small form-factor pluggable) Networking/LAN ports 1-4
(JX1_SFP1)
SW1 (UID)
UID (Unit Identification) switch
(BP) USB 2/3 (2.0)
Backpanel USB 2.0 ports 2/3, 4/5 (USB1)
USB0/1 (2.0)/USB6/7
USB 2.0 connections 0/1 or USB 3.0 connections 6/7 (optional)
(3.0) (JUSB3-1A)
(Optional)
USB4/5 (2.0)/USB8/9
Backpanel USB 2.0 ports 4/5 or USB 3.0 ports 8/9
(3.0) (JUSBRJ45)
VGA
Backpanel VGA port
LED
Description
SAS Heartbeat LED for SAS connections supported
DS1
by the 3008 SAS controller located at US1
SAS Heartbeat LED for SAS connections supported
DSX1
by the SAS 3008 controller located at USX1
DX1, 2, 5, 6
SFP/LAN1-SFP/LAN4 Link LEDs
DX3, 4, 7, 8
SFP/LAN1-SFP/LAN4 Activity LEDs
LE2
Onboard PWR LED
LE4
Rear UID LED
LEDM1
BMC Heartbeat LED
State
Green: Blinking
Green: Blinking
Green: On
Green: Blinking
On
Blue: On
Green: Blinking
15
Chapter 1: Introduction
Status
SAS Normal
SAS Normal
10Gb Link
LAN Active
Power On
Unit Identified
BMC Normal
Advertisement
Table of Contents
