Table of Contents
Advertisement
SuperStorage Server 6048-E1CR90L User's Manual
Installing a 3.5" Hard Disk Drive
With the drive carrier removed from the storage compartment:
1. Under the main the carrier handle, find and the lift the breakout lever and pull out the
side of the carrier.
Carrier
Breakout
Lever
2. Remove the dummy drive from the carrier.
3. Insert the hard drive into the drive carrier. Orient the drive by matching the two
alignment pins on the side and by noting the notch in the carrier for the HDD
connectors. Close the side of the carrier until it snaps in place.
4. Slide the carrier assembly into its spot in the chassis until it clicks into locked position.
Alignment Pins
Notch for Connectors
Figure 3-7. Opening the Drive Carrier
46
Pull Out Side
of Carrier
Advertisement
Table of Contents
