Supermicro SuperStorage Server 6048R-E1CR90L User Manual page 82

SuperStorage Server 6048-E1CR90L User's Manual
Non-Fatal Err (Error) Over
Select Enable to force a non-fatal error that has occurred to the port specified by the user
to be prorogated to the II0 core error logic. The options are Disable and Enable.
Corr Err (Correctable Error) Over
Select Enable to force a correctable error that has occurred to the port specified by the
user to be prorogated to the II0 core error logic. The options are Disable and Enable.
L0s Support
When this item is set to Disable, II0 will not put its transmitter in the L0s state. The options
are Disable and Enable.
PM ACPI Mode
Select Enable to generate an _HPGPE message on a PM ACPI event. Select Disable to
generate an MSI message. The options are Disable and Enable.
Gen3 (Generation 3) Eq (Equalization) Mode
Use this item to set PCI-E Gen3 Adaptive Equalization mode. The options are Auto, Enable
Phase 0, 1, 2, 3; Disable Phase 0, 1, 2, 3; Enable Phase 1 Only, Enable Phase 0, 1 Only,
Advanced, Enable MMM Offset West, and Alt Short Channel.
Gen3 (Generation 3) Spec (Specifics) Mode
Use this item to set the Specifics mode for a PCI-E Gen. 3 device. The options are Auto,
0.70 July, 0.70 Sept and 071 Sept.
Gen3 (Generation 3) Phase2 Mode
Use this feature to configure the Loop-count settings for PCI-E Gen3 Phase 2. The options
are Hardware Adaptive and Manual.
Gen3 DN Tx Preset
Use this item to select the preset setting for a downstream component transmitter. The
options are P0 (-6.0/0.0 dB), P1 (-3.5/0.0 dB), P2 (-4.5/0.0 dB), P3 (-2.5/0.0 dB), P4 (0.0/0.0
dB), P5 (0.0/-2.0 dB), P6 (0.0/-2.5 dB), P7 (-6.0/-3.5 dB), P8 (-3.5/-3.5 dB), P9 (0.0/-3.5
dB), and Auto.
Gen3 DN Rx Preset Hint
Use this item to select a preset setting for a downstream component receiver. The options
are P0 (-6.0 dB), P1 (-7.0 dB), P2 (-8.0 dB), P3 (-9.0 dB), P4 (-10.0 dB), P5 (-11.0 dB),
P6 (-12.0 dB), and Auto.
Gen3 UP Tx Preset
Use this item to select the preset setting for a upstream component transmitter. The options
are P0 (-6.0/0.0 dB), P1 (-3.5/0.0 dB), P2 (-4.5/0.0 dB), P3 (-2.5/0.0 dB), P4 (0.0/0.0 dB),
P5 (0.0/-2.0 dB), P6 (0.0/-2.5 dB), P7 (-6.0/-3.5 dB), P8 (-3.5/-3.5 dB), P9 (0.0/-3.5 dB),
and Auto.
82