Supermicro SuperStorage Server 6048R-E1CR90L User Manual page 90

SuperStorage Server 6048-E1CR90L User's Manual
sSATA Port 0 ~ Port 3 Hot Plug
Select Enabled to enable hot-plugging support for a port specified by the user, which will
allow the user to replace a sSATA disk drive installed on this port without shutting down
the system. The options are Enabled and Disabled.
Configure as eSATA (Available for the sSATA Port 0 Only)
Select Enabled to configure sSATA Port 0 as an external sSATA port. The options are
Enabled and Disabled.
sSATA Port 0 ~ Port 3 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRESET
initialization to the device. The options are Enabled and Disabled.
Port 0 ~ Port 3 sSATA Device Type
Use this item to specify if the sSATA port specified by the user should be connected to a
Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State
Drive.
*If the item above "Configure sSATA as" is set to IDE, the following items will display:
sSATA Port 0~ Port 3
This item indicates that an sSATA port specified by the user is installed (present) or not.
Port 0~ Port 3 sSATA Device Type (Available when a sSATA port is detected)
Use this item to specify if the sSATA port specified by the user should be connected to a
Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State
Drive.
*If the item above "Configure sSATA as" is set to RAID, the following items will display:
sSATA RAID Option ROM/UEFI Driver
Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy OPROM
for system boot. The options are Disabled, EFI, and Legacy.
SATA/sSATA RAID Boot Select
Select SATA Controller to boot the system from a SATA RAID device. Select sSATA
Controller to boot the system from a sSATA RAID device. Select Both to boot the system
either from a SATA RAID device or from an sSATA RAID device. Please note that the
option-Both is not supported by the Windows Server 2012/R2 OS. The options are None,
Both, SATA Controller, and sSATA Controller.
sSATA Port 0 ~ Port 3 Hot Plug
Select Enabled to enable hot-plugging support for a port specified by the user, which will
allow the user to replace a sSATA disk drive installed on this port without shutting down
the system. The options are Enabled and Disabled.
90