Mitsubishi Electric MELSEC iQ-RJ71EN71 User Manual page 59

Set the gateway as follows.
To transmit communications to the request destination
the IP packet passes through the station
with the network address No.
Request source
4.
Write the set parameters to the Ethernet adapter module 1.
■Setting in the CPU module 1 and master station 1 (station No.0)
1.
Set the routing parameters to the CPU module 1 as follows.
[Navigation window]  [Parameter]  Target module  [CPU parameter]  [Routing Setting]
Because the network address is different from that of the request destination device, the Ethernet adapter module 2 (Ethernet
part) does not have a network number. Set the communication path to the network No.2.
2.
Set the IP address in the master station 1 (station No.0) as follows.
[Navigation window]  [Parameter]  [Module Information]  Target module  [Application Settings]  [IP Address]
3.
Write the set parameters to the CPU module 1. Then reset the CPU module 1 or power off and on the system.
■Setting in the CPU module 2, local station 1 (station No.2), and master station 2 (station No.0)
1.
Set the routing parameters to the CPU module 2 as follows.
[Navigation window]  [Parameter]  Target module  [CPU parameter]  [Routing Setting]
2.
Set the IP address in the master station 2 (station No.0) as follows.
[Navigation window]  [Parameter]  [Module Information]  Target module  [Application Settings]  [IP Address]
3.
The IP address setting is not required for the local station 1 (station No.2).
The network address set in the master station 1 (station No.0) is automatically assigned.
4.
Write the set parameters to the CPU module 2. Then reset the CPU module 2 or power off and on the system.
,
and station No. .
Station where the IP packet passes through last
(Network No. , station No. )
Request
destination
1 FUNCTIONS
1.3 IP Packet Transfer Function
1
57